LUYED 1200 Lumens Super Bright 3020 6-EX LED Auxiliary Back Up Camera Parking Reverse Light System.Patent Enhances Night Performance LED Tail Light Camera Illumination 6500K White for Car Automotive

out of the box, impressed with the quality. bought more already.

This light is amazing! I purchased it to compliment some LED underglow lights (xprite pickup bed lights with custom extension cables, 5 pods per side). I needed something to light the front of the trailer so nobody would put a shin into the hitch coupler at night. I mounted this to one of the battery support cross bars, facing forward, and tied it into the switch for my other under glow lights.This baby puts out some serious light! I'm now wishing I would have just bought 10 of these and used them for undercarriage lighting instead. I don't know how much power it draws but my 30 1.5 watt LEDs under the sides of the trailer run right alongside this unit without popping the 5amp fuse so draw can't be much.I installed 4" rather large LED flood lights on top of my rear RV bumper as backup lights and in hindsight, 2 of these mounted discreetly underneath the bumper would have done a similiar job. I may end up swapping for a pair of these if I have any issues with the flood lights.I did notice the metal housing gets rather warm during extended use whereas my other LED lights generate no heat at all. I like that the housing is metal but do worry about the heat buildup if run continously. We'll see how it holds up this camping season, but right now I'd shy away from mounting it to a wood or plastic surface just to be safe.

Very bright, very small placement, use, and a lick of paint/sealing will make them last

These lights are CRAZY bright, I am shocked and so happy with the color temperature. They look amazing. Initially I had purchased 2 and both happened to be faulty (I’m guessing a bad batch) i contacted luyed and they quickly refunded my money which was great, but I still wanted to try these out so I decided to get another because I like their design and style, and WOW they didn’t let me down. I’m going to buy 6 more!The color temperature is PERFECT 5k they aren’t that gross 6k that has a slight blue hue to it. I like pure crystal white and these fall nothing short of it, they are so damn bright it’s hard for me to believe it haha.I can’t recommend these enough, I’m going to make a YouTube video on these, that’s how much I like them.MaxxxPayLoad is my YouTube channel I’ll be uploading after I order 2 more and install them.It should be in the next 2 weeks.

After installing a backup camera on my Altima, I discovered that the OEM backup lights were on the dim side. So I looked for a solution.PROS:-Very bright. Even tho I'm using two, (1) would have probably been enough. These even help at Dusk.-Nice low profile. They are barely visible mounted at the top next to my license plate lights.-Not adjustable. This may sound like a Con, but I didn't want the extra height of an adjustable model nor worrying about the adustable bracket coming apart. For me, the low profile is great.-Did I mention how bright these are!?CONS:-Wires aren't very long. If your mounting location is on the body vs the trunk lid, and not too far from your Backup lights...you'll be ok. But I wanted to mount these on the underside of my license plate housing next to the license plate lights, which is on the Altima's trunk lid. And the wires had just barely enough length to reach the wiring going to the Backup lights on the body. 6' sounds like a lot of wire until you have to route it thru the trunk lid, past the hinge(leaving enough to flex with the movement of the hinge), and then back to the Backup light wiring near the fixture. I traced the wiring to as close to the hinge as possible, but it was just barely enough to make it. I would suggest adding 2-4' to the wiring provided with the lights. You can always shorten wire, but adding wire can end up being problematic in the future..-Power wires are very thin. I would prefer it if the wiring was a little thicker gauge. Would also prefer having a different kind of insulation. The wire insulation was difficult to safely remove due to the small gauge of the wires. It's a molded type vs a sheath style. In order to connect the wire to the Ground and Backup power wires, I needed to remove about 8" of insulation.-No Protective Grommet or Sealant where the wiring emerges from the light. There's just a hole where the wiring exits the light, thus alowing dirt and water to enter and the wiring to rub against the metal. Eventually either water or road vibration would cause a failure, so I sealed the hole with Outdoor RTV. This caused me a 24hr delay in installation to allow the RTV to fully cure.Overall, I love these lights. They work great, would buy again..even with the Cons. I've had them for 3 months now and no issues.

im glad i found this in Amazon, didnt know they have something like this at first. Installation was super easy, tapped into the OEM reverse bulb and done. Hiding the wire took me longer for my RX330. Considering getting another one for my other car.

Bought 5 of these, put 2 on my truck as backup lights and 2 on the wife's van, 1 for backup camera and the other on the inside of the lift gate for better lighting in the back.On my truck they provide rear/side lighting for reverse, very bright. Light radius is about 15 ft.The van it seems it is almost too bright for the camera and it kinda distorts the picture but it helps more than it hurts to it stays. On the inside, I have it wired to come on when the rear hatch is opened. Lights up the whole cargo area and about 10ft out the back of the van, helps a lot over the factory lighting.

Received different model, check in the pictur, in the advertisement showing different shape which is really nice but the i received is totally different.Seriously very nice Metal body but there is no space to hold with reverse light or reverse camera. Not sure how they can design to stick outside with doubled sided tape...! definitely its not weather protective. Once u do carwash it will comeout.I overlook the comments about wires, which are really extremely thin short check the pictures.