BOOT FOR W5350

If you jealously take care of your tools, then you’ll be very happy with this boot. Plastic is little over 1/16” thick and has a durable feeling and fit like glove. It is some how hard/tricky to put on but is possible without demanding the boot. Like the other successful customers, I use a heat gun and directed the heat to the inside but mostly to the side of the boot. I was able to hold the boot while been heated so does not take LOTS OF HEAT. Ones is hot enough, just push it down firmly if the Shank gets stuck on boot, lift it up with a screw driver and keep pushing. Case closes little snug because of the added thickness of the boot to battery and tool it self but does close, extra battery only fits upside down do to the molded tabs in the case.

I got this for the W5350 1/2" as described in the description, but it might not hold up for very long. It is very obvious upon receiving it that it is meant for the W5330 3/8" and required the use of a heat gun, patience, and lots of tugging. The rubber is stretched and stressed already around the corners after cooling down from the heart gun after rough fitment and will forcibly fit back into the tool carrying case. It looks nice but I'll see how long it will last... It's better than nothing right now.

Initially, I felt this item was overpriced, however, its value in protecting the tool is unquestionable. I use it on my # 5350 1/2" right angle drive even though its description says it is for the 3/8" Impactool. It fits perfectly allowing the tool to be carried in the original, blow-molded tool case. It was a bitch to install! I used a heat gun and a wide screwdriver to CAREFULLY leverage it onto the tool. Once on and cooled it fits almost seamlessly. Use caution that you do not tear it when installing. I use it in conjunction with the Ingersoll-Rand BL2005 Protective Battery Boot. I am very pleased with this purchase.

If you work in an environment with abrasive surfaces and like to keep your tools in as good a condition as possible then this protective boot should be well worth the investment. I say "should" because this is the first rubber impact tool protector I have owned, my others are leather and they're still working great after 20+ years.I couldn't get this protector on the tool without heating it up slightly to give it additional stretch. I used a common hair dryer set to high, a hotter industrial heat gun would be unnecessary. This boot fits both the Ingersoll Rand W5350 1/2" and W5330 3/8" models, my tool is the W5330 3/8" model.

Quick way to install: place boot in plastic bag; submerged in hot water (kettle) for 5 mins, remove from water then plastic bag. Install over tool using grippy gloves 👍 After of cools down, fits like a glove

Very difficult to install but, once accomplished, performes as claimed. Ridiculously over-priced for a $2 piece of plastic. Yeah, well. Apple does it, too. And we buy billions of them...go figure

HOW DO YOU INSTALL THE BOOT FOR W5350???I USED HEAT THEN OIL AND IT TOOK ME OVER 1 HOUR AND I DID INSTALL THE BOOT BUT WITH A BIG HOLEI BOUGHT BOOTS BL2205,BL2010,W5132 BOOT,BL2010 AND W7150 BOOTI DIDN'T HAVE ANY PROBLEMS AS I DID WITH W5330 BOOT-10 STARS

Use a fair amount of heat and it will stretch also be patient it will stretch to the point you might think it would tear