Bialetti Pack of 3 Gaskets and 1 Filter for 6-Cup Espresso Coffee Maker Aluminium

As described. Fits well and does it's job

Great value.

Used to replace the filter and seal on my Bialetti espresso coffee pot.Arrived on time. Easy to fit and good quality.Well recommended.

Many people have complained it doesn't work so I thought I'd share what my coffee obsessed italian girlfriend did to make things run smoothly. First make sure you put the filter in the right way round (like a saucer not a hat) and secure with the seal. Then put it on the hob with just water in it. Let it cool and do it again a couple of times. It needs re-training! Then run the water through once before you put coffee in for the first week or so of using it. Don't fill the coffee to the top and don't squash it down. It's very important to put it on a low heat, the lowest you have. If the water evaporates too fast it'll saturate the coffee too fast and you'll never get anything out. You can also rinse the bottom part of your moka under the cold tap mid coffee brewing if it looks like it's not coming through. My moka is now back to working like a tank only without the tiny bits of rubber I got with my old seal. A moka is one of those things that need a little love, care, and attention to work properly (much like knives or cast iron pans). Hope this helps, happy brewing!

These are genuine, they work. The rubbers do have a tendency to desintegrate after about 6 months, so having three spares is always a good thing seen as the coffee my bialetti makes is the best...so long as you get the best beans that is

Gaskets in each of our Bialetti pots had reached terminal stage, but wasn't sure of size (by cup). So glad I eventually bought these replacements. Really easy to fit, and great seal again. Now get to drink all the coffee rather than it escaping and burning onto the aga. This pack is for 6 cup mocha etc. If it helps you decide if it's the right one for yours, the seal measures 7cm in diameter (from outside edges).

Very easy to replace the old seal. If your seal is really old it might need prying/cutting out with a knife or pliers and a bit of wire brushing. The new gasket slots in and may require some light finger pressure to push it into place. Revived my Bialetti for a few more years.

Needed to replace the rubber gaskets on my Bialetti moka. These did the job perfectly. Very easy to swap over. Only downside is that I had to wait weeks to receive them as they were sent from the USA although it said when I ordered them that they would be sent from the UK.