💼 Elevate Your Laptop's Look with Confidence!
The KBRPARTS Laptop Keyboard Cover is a brand new, original replacement for Lenovo ideapad 5-15IIL05, 5-15ITL05, and 5-15ARE05 series laptops. This dark blue LCD rear lid back cover assembly comes with hinges and is designed for a seamless fit, ensuring your device not only looks great but is also protected. Professional installation is recommended for optimal results.
M**L
Great replacement
Great quality. Looks and feels just like the original one. Maybe even a little better. Installed on an Ideapad 5-15ITL05
T**Y
Good, compatible replacement for IdeaPad 5
Worked very well. For my IdeaPad 5, there was a small piece of plastic (about an inch in length) that you must remember to re-attach on top, near the hinge, during reassembly!I used “Thread-Locker” glue for ALL hinge screws.
P**B
So worth it
The laptop is new again! We did not have to buy a whole new laptop. Following Youtube videos to install and it works great!
M**A
Not durable
The product is fine but lasted only for 6 months. After that, same problem.
C**B
Perfect fit!
An easy replacement for my Lenovo Thinkpad 3. It comes with the double sided tape already so it was an easy install. It took more time to dismantle the laptop than it took to fix it.
C**E
Expensive but works
It works as intended it’s just unfortunate that it costs half a laptop.
J**N
Exact match
Had to replace the cover as one of my hinges broke loose. This matched identical including logo, color and hinges to the Lenovo cover I replaced.
K**A
A Relatively Easy DIY Replacement
The hinge on my laptop broke pulled out of the cover, so I ordered this replacement cover w/hingesReplacement wasn't too difficult for me w/guidance from a YouTube video. It took a few hours and required a very small torx bit ($8 for a small screwdriver set).If you are going to replace the cover yourself, be sure to find an instructional video. I would have probably ruined my lcd screen had I not followed instructions on how to remove the double-sided adhesive holding the screen to the cover. Also, be sure to find a video on how to remove the camera. It's just attached with adhesive. I had to use a little spray adhesive to make it stick again.The new hinges were very stiff. I was afraid the mounting screws would soon pull out of the plastic cover again, so I lubricated the hinges with silicone lubricant and loosened the nuts a bit. The cover now opens and closes easily and stays where I position it.All in all, for the cost and a few hours of work, it was well worth it. I'm very satisfied.
Trustpilot
3 days ago
1 month ago
