š Elevate Your Experience with Unmatched Power!
The BW RC Servo BEC UBEC is a high-efficiency power supply designed for RC helicopters and airplanes, providing a stable 5V / 3A output while ensuring safety with advanced protection features. Its compact and lightweight design makes it an essential component for any serious hobbyist.
R**T
very nice for combat robots
Surprisingly good for combat robots, since many of their escs and transmitters don't have BEC circuits. Can drive anything and is nice and sturdy compared to other BECs
T**.
Works well but electrically noisy
TL;DR, this product is great. Does exactly what it says and seems to be reliable over hundreds of operating hours so far. Only draw back is that it's not as electrically quiet as I'd hoped for."I bought this as an alternative for powering a Raspberry Pi Zero. This Raspberry Pi Zero is the controller for a radio project I've been working on. Traditional USB "wall wart" power supplies were generating a lot of electrical "noise" across the radio spectrum. I decided to ditch the AC to DC converter in hopes of getting rid of the noise and instead use one of these UBECs to run it off a 12v battery (The Pi uses 5v). It works perfectly for this. Unfortunately, it still produces electrical noise. Not as much as I was getting before, it's much less spread out across the bands than the AC to DC, switching power supply was but I wish it was just a little quieter.
B**O
Works great
I used this to power my arm-mounted Raspberry Pi in a Pip-Boy project off of a 12V battery pack. Works great!
D**R
Great product
This work real good easy to install make sure you get a Raspberry Pi pinout diagram so you know where to put the plugUpdate !!!I hooked it to my 24 volt power supply corn my 3D printer and fried it which is my fault because it says 23 volt Max so I'm not blaming this thing still a great product
D**N
Good UBEC
I like that they added a toroid coil to help suppress RFI. I am using these for Raspberry Pi power supplies using a higher voltage source, like 12 VDC. They work well.
P**.
Product works like it says š
The bec didnāt have enough coverage on the board afraid it might get moisture inside and short it out..I used it to run my light bar because light bar is only rated to handle five volts..words great
C**N
Works well, but be aware that it draws power ...
Works well, but be aware that it draws power when the batter is connected, even if there's no load on the other end. So just make sure to disconnect the battery after use.
D**S
Simple and Strong. Voltage is a bit higher when lightly loaded, but it holds in there at 5V when loaded down.
Puts out 5.2V when lightly loaded but holds in great at 5.0V when loaded down by my receiver and 6 digital servos all at full diflection. Works great and servos maintain there fast speed. The description says there is an LED indicator, mine did not have one or it was not working; that didn't matter for to me for my application.
D**S
couldn't be more pleased .
Using it to drop my2 cell lipo 8.2V to5 volts on mygas powered airplane
Trustpilot
2 months ago
1 month ago