EWK 1 to 2-1/2 Inch 3 Stones Engine Cylinder Hone Tool Adjustable Cylinder Deglazer Piston Honer 220 Grit

Well packaged and arrived quickly in good condition. Oiled up the stones and bore, set a little tension and used LOW RPM up and down for two 20 second cycles. Bore looks factory fresh. Nice 45 degree angular cut. If you know how to use a three stone hone this will get the job done !!

Very well made tool. Very pleased with the quality for the money. I didn’t have any problems with the stones breaking or coming loose. The edges of the stones round over after a little use. I have gotten great results in two scored cylinders so far.

Do not expect it to be ready for use out of the packaging. It fell apart immediately after I started using it and spent the next 10 minutes searching for the parts and figuring out how it all went together. After that, it did give the desired cross-hatch on my motorcycle cylinder. I also put thread locker on the hone threads to make sure it stayed put for the next use.

I got this to hone a new cylinder for my motorized bike. It's good quality, and did the job perfectly. I used WD40 for the cutting oil, that's all ya need.Hope this helps!

Used to hone or rebuild 2cycle engine worked great.

This did a good job but the stones were very quickly.

Good value for money easy to use held up good. Just dont put drill in reverse makes it fall apart

As described and very good quality materials! Used heavily for my LS 5.3! Still plenty of pad left