JTSprockets JTF259.17 17T Steel Front Sprocket Natural, 17 Tooth

Couldnt have been more simple, Remove the sprocket housing cover, use a 10mm socket with an extension to make it easier and remove the two screws holding the sprocket in place. pull the old one out carefully and clean the area while you have it open. then just place the chain on the sprocket and put the new one back onthe same way. all in all took about 15-20 minutes. These particular Jt sprocket are completely compatible with a hawk 250 and other variants of this bike.

Worked great on the RPS X Hawk 250. Bolted right on. did not have to shorten the chain. But you'll have to move the wheel axle almost all the way forward. your top speed will increase to 60 MPH by just changing the front sprocket. Soon I'll change the rear sprocket to a 45 tooth. Than I should be around 70 mph top speed.

Great sprockets always on point

You'll have to mount sprocket cover first, then feed chain onto sprocket, but does work and fit.

good price , good quality , 17 teeth

I have a couple Chinese made Motorcycles that use this as a front sprocket.They originally had a 15 and a 16 tooth sprocket on the front, being a lighter rider (under 130 pounds) I don't need all that torque to climb vertical telephone poles the 15t has... and the 16t helped stretching the gears a little bit, but RPMs are still screaming at highway speeds in final gear.Moving from the 16t up to a 17t, I lowered the RPMs about 400 at any given speed. Was also able to get these little 198cc Lifan engines to get upwards of 120 miles per gallon on a few trips after the sprocket change.Carefully check clearances before you go for a ride, some engines have just enough space for the 16t as the largest sprocket.

fit on hawk 250 had to grind some of my cass to use x rig chain

Great product, well made. I installed these along with a new chain. Zero visible runout. Bolts right up to the RPS Hawk-X.