The TL4 is our standard 4 inch LED Industrial Traffic Light or Dock Bay Stop Go Light. It has a sturdy black aluminum housing to ensure durability in harsh weather environments. The TL4 is suited for use in truck dock bays, fork lift intersections, and roads & parking lots. It has 45 bright LED's to ensure maximum visibility. Equivalent to SG10, SG20, and SG30 Stop and Go LED Loading Dock Safety Lights.
A**R
Must find your own power cable
Picture shows a cable from the bottom. However, you have to find your own cable to wire and power it. Absolutely pointless!! Very unhappy
L**T
Good product
Product is of good quality, wiring it was a little difficult.
J**G
The green is noticeably brighter than the red.
I’m using the product for entertainment. I enjoy having it setup in my home.
C**A
Where are the wires (the power source) to hook it up?
I have a contractor hanging this in my office and they are asking where the wire is for the power source for it to light up? The photo indicates from the bottom of the machine that something should be connected in there but there is nothing in the box other than the light and mounting brakets
J**E
Works well, surprised on brightness
Verify voltage first. Installed outside USPS loading dock. Well made, LED and super bright.
D**B
Terrible purchase for my needs.
It gives the appearance that it has wires coming out of it to hook up to something, but it is not. Trying to figure out how to send it back.
M**E
Electronic item not handled with care
I hope it still works my daughter brought it into the house and sent a photo to me there is a huge hole in the box
S**Y
Mine had power cable and knob controls
The mounting pieces have the machined holes a bit off. Not a big deal, but put flush with the box, the screw holes to the box are 1.5mm off which would increase when a screw is in the bracket to the wall. Better to put a slide hole for varying screw head clearance. Will open it up on my drill press.I had this on my wishlist for quite some time. I think this is a newer model as I’d also purchased a computer controller. Lights are a constant on so I’m hoping the controller will randomize if the knobs are left in the on position.It has a little dent in the back from shipping, but will be covered by the brackets to mount so I’m not overly concerned.I’d just suggest slider holes for the screws that attach the bracket to the unit. I’ll just add 4 rubber washers and paint the screws because I like the powdercoat.
Trustpilot
3 weeks ago
2 months ago
