Spurtar Car Pinstripe Tape, Pinstriping Automotive Tape, Vinyl Thin Car Fine Line Decals, Motorcycle Boat, Racing Stripes, 2 Rolls x 33Ft, Silver, Chrome,2 in 1 (1/5” Stripe+ 1/10" Gap+ 1/10” Streak)

One day delivery. Quality product. Very easy to use. Car looks great. Good price. Very cheap way to add a little pizazz to your car.

Easy install and great adhesive

Great fit easy to use,looks great

Installed easily and low cost.

Bought a solid black 2015 Ford Explorer and put some 20" rims on it with a red stripe on them, and the car just needed "a little something extra". Install was super easy, just clean the surface and take your time (whole car took less than 2 hours start to finish. Already got several compliments! Definitely worth it.

Spurtar 2 Rolls x 33Ft Car Pinstriping Tape, DIY Vinyl Pin Striping Decals, Blue.Put stripes on my 2023 RAM 1500 Limited. I wanted to do something to make my big white truck look different from other big white trucks so I decided to stripe it. People think (or at least say) I did a good job.I like it.I put these on before Christmas but held off on a review to see how they wore/lasted on the truck. I think they still look good and I have not had any ‘LIFTING” of the stripes. They seem to be working just fine.March 2024:I reordered these stripes as I had the tips of the stripes on my front fenders start to lift. I had cut them at a sharp angle and the very tip began to peal. I also didn’t like that I had placed them an inch below the belt line.They came off cleanly and I re-did the job. Note the front fender pic showing how I “folded” the tape under the edge of the fender. Overall I still like these stripes. All other areas held just fine.

I have sort of started a tradition of pinstriping my bicycles. There were several identical bikes among some friends, so I added a pin stripe to distinguish them in a group. This pack includes two stripes with a wide and narrow line. You can use both or only one depending on your area and preference. I would suggest cutting some test strips and putting different combinations to find what is the most appealing to you. If you are only going to use one, I would suggest putting both on after installing, removing the unwanted strip. When removing the top cover, pull in the same direction as applied. On bicycles, I have had strips stay on for 10 years. Not sure how they hold up on automobiles if you would run through a car wash but if you pin striping your care, you are likely hand washing your car anyway. I wish they would provide a few more end pieces. I don't always use them but there are times it would be nice to have a few more.

i tried to redo the pin strips on my truck but after using soap and water to clean even use non abrasive alcohol. the strips still do not stick but keeps peeling off