Taramp's MD 1800.1 1 Ohm 1800 Watts Class D Full Range Mono Amplifier

What a value this amp is. I bought this amp to replace a 2000 watt Hifonics Hercules that got fried and let me let you "You get everything that you pay for and then some."This amp is not overrated and hasn't overheated yet. I know it's hard to believe with all the other manufactures promising big numbers for little money and not delivering even half what they are rated, but this amp is an exception. Rated at 1800watts I'm running it to two 12" dual 4ohm voice coiled Rockford Fosgate T1 subs rated at 1000 peak / 600 watts RMS per sub and they are a perfect match. Lots of power and lots of bass! I'd recommend it to anyone. Just buy one and you'll see.

this thing is a beast works great just needs power. upgrade your electrical with a big 3 and add a xs power amg battery and you will be set. got it running 2 ct sounds 10" tropos dual 4 ohm subs at 1ohm. It pounds for 2 10" subs. they are 650rms 1300rms for both got the gain about 1/4 with no clipping. I did buy the clipping light that is really a must.

I have it connected to three Skar SDR D2 8's and it pounds. The sound quality doesn't compare to Rockford, which is my go to. But for the price it is amazing. Puts out more then enough power. I recommend OFC wire. I burned the CCA ground wire that was in my truck. Current is to strong. Glad I purchased it.

Honestly this little amp is unbelievable I didn't expect it to pump out this much power make sure you have enough power to run it though this thing is notorious for popping fuses if it's not high enough this thing can pull up to about 260 amps so make sure you have an aftermarket alternator and battery and you're probably going to want to use 0 gauge wire other than that this thing slaps my Fusion 15s so hard I almost broke off my back hatch absolutely love it definitely will purchase another one

Absolutely a monster for it's size. This amplifier will perform properly at rated power as long as it is supplied with enough amperage. Amps can show a clipping signal if amperage dips below requirements. A stock 150a - 200a alternator won't be enough, even with a secondary battery at full tilt. With a 300a+ alternator, you can run full tilt all day long until your voice coils melt.

I use this product to upgrade and amplify my stock radio sound system and this product to my surprise did everything and more that made me a very satisfied customer of this product.

I bought this amp off the reviews. Does not give you the watts it says. I'm running 1 American Bass 12' speaker, makes the amp clip. Too high it protects itself. Probably gives you about 500-600 rms tops. I wouldn't recommend it, had a kicker 400.1 and it would rock 2x as hard as this one. Just go with another brand.

Tested the 1 ohm 1800 RMS amp from taramps on stock 220 amp alternator, and does not get to full RMS power. Tested the amplifier with an oscilloscope and it started to distort/clip somewhere in the 500-watt RMS @ 40hz @ 2Ohm and 1400 RMS @1ohm @40hz maybe is a defective unit or maybe is my electrical but judging from the videos I have seen about this amp it is most likely my electrical because this draws a lot of current. I'll stick with my Rockville db14 I can get 1000 RMS at 2ohms on stock electrical and no distortion. JUST FYI you need a great electrical system for this taramps amplifier.

Excelente producto, con buena potencia, buen diseño y muy funcional

Product works as it should. Clip light is close to accurate. Under-rated output power does almost double the rms. Been pushing 2 12" massive gtx 124 rated at 700w rms each without an issue.

En mi opinión si trae la potencia estipulada en sus características

Does rated power or more I believe but cheaply made, knobs are hard to turn, cooling fan is loud and does not come with a gain knob. Best thing I liked is the size of it cuz limited for space. Gets the job done for a good price.

Boa potência e ótimo consumo!