MOTOALL Fuel Injector Connector EV1 OBD1 Plug Wire Harness Pigtail Wiring Loom Clip Cut & Splice 2-Wire Female - 8pcs

I was researching alternatives to buying genuine Bosch connectors when I came across these, being ev1 I figured they must fit (although for some reason it says they don’t fit my 84’ BMW 325e) I took the risk and they matched up perfectly! Being pigtails made install for an easy install compared to repinning. Car is back up and running with no issues! Would recommend especially since these were the cheapest ones I found

For Ford dually superduty trucks (early 2000's, maybe others), these work perfectly for the side marker lights on the rear fenders.You don't need to buy a new $300 harness if the ends go bad, and definitely don't need to buy the exorbitantly overpriced replacement pigtails. Cut off the old ends, solder these in place, plug them in to the lamp housings and you're all set.No, I don't work for the company selling these. I'm just trying to spare you the time and disappointment of trying to find replacements that aren't insanely overpriced.

I used these to replace the injector plugs on an 05 harley-davidson and they fit perfectly. No problems in 2 years

These were such a better design than the origionals. I redid a fuel injection harness with these. For a 95 F-150 4.9. as far as longevity we will see. I used heat shrink over these to secure the wires to the body of the connectors. And reduce damage generated by heat from the engine. They worked well. And the metal clips made a solid connection. And made it easy to quickly remove if needed. I ohmed these all out after I rebuilt the harness. All were good to go.

Fixed electrical connection problem of oem ones being worn & falling off

Better than I thought it would be. Fixed my 5.8l

They clipped right on to my Bosch Ev 1 style injectors. These went on a 1987 Jeep Cherokee 4.0 and have the modern push to release clip much nicer than the old pry off with a pic style clips that the jeep was originally born with. They work as expected. We will see how long they last the 4.0 L motor generates quite a bit of heat under the hood I am not expecting oem performance out of them. Very easy to install I used a soldering gun add marine shrink wrap to complete the connections.

The connector shell seems to be of good quality, and they fit the injector well, but the pigtail seals are not installed correctly. The seals are supposed to be crimped to the contact so they are held in place when the wires are inserted into the shell, but these are not so they tend to be out of position most of the time, either too far in or too far out. The first photo shows that the seals on this connector are so far down inside the housing that the seal will not function properly and moisture will get to the contact. I pull the wires and crimp my own contacts so I don't really care about the seals, but if you plan to use the pigtails, be aware that they might not seal out moisture!The second photo shows how the seals looked on the pigtails from the first photo, the third photo is an example that shows the correct way for the seals to be crimped to the contact.The contacts and the wire are ok, not top quality, but not bad, and the crimping of the contact to the wire looks top notch. Too bad they didn't crimp the seals too!