SMALLRIGSuper Clamp with 1/4"-20 Thread Holes, 3/8"-16 Locating Pin for ARRI Standard, T-Shaped Wingnut and Rubber PadsClimatePartner certified

I have been using this Clamp for iPhone to take selfies on trails and such, and always managed to clamp it to whatever happens to be around on trails, roads, restaurants. Today I am ordering a second one, to mount the rear view dash cam unto the wind deflector of my convertible car (an SL55). I had tried using five different RAM mounts that I already had on hand but none worked. Then I remembered this SmallRig clamp, and it worked perfectly! A solid, non-permanent mount was achieved.

Works great for mounting my 7" monitor on an arm.

Great for creative mounting options!Strong grip, well made , multiple mounting points, & a small footprint while still having a wide mouth with rubber pads.Can't really ask for much more at this price.

Fixed it on a cylinder of a deskchair to prevent the chair going downwards..

I purchased this because I needed a truly "super" clamp from SR. Truth be told, this isn't much bigger than their regular clamp. The major differences are there are more mounting points. BTW, there IS a 3/8" mount. It's where the Arri locating pins are (duh). The diagram shows a 3/8' sized hole, but it is not threaded. The T handle is pretty beefy, but I don't think it's worth the price point.

The media could not be loaded. What I liked is this clamp has a variety of mounting points versus just a couple where it hinges. I also appreciate that it can take a crankn. That rigging shown is probably heavier than the working load is for this item, but it held in and in place.What I would have liked was the "tightener" to have been the spring loaded type for cramped spaces.There aren't many clamps with multiple mounting options, and this did the job for me...overloaded.

These are solid, clamp hard, and stay put. They have multiple standard tripod lug receptacles and they were perfect for my setup.

This clamp slips off anything I clamp it down to

I have a couple of super clamps that I mount to a tripod and attach and external monitor via articulating arm when I’m doing video or even headshots. This new version of clamp with the Arri locating pins is magical. I always had problems with the weight of the monitor helping to unscrew itself and now with my SmallRig articulating arm with Arri pins locked into the super clamp, no more rotation. My only mistake was ordering one. I will be getting another soon.

Worked well

This clamp is very useful for accessories mounting on tripod legs. But you will need two of them in parallel to avoid them sliding out of angle. That can be solved if you don't need to worry about over tightening (e.g. deforming a hollow tripod leg). If you're mounting it on the edge of a board, you can tighten it enough to avoid this.

Works great, exactly as expected. But if you don’t need the ARRI holes you can buy the cheaper SmallRig super clamp without it - they are the same size. If you are looking for an alternative to Manfrotto super clamp this is way smaller.