Primefit PCKIT26 Air Piping System, 26-Piece Air Push to Connect Kit with 1/2-Inch (OD) / 3/8" (ID) x 100-Feet TPEE Tubing

Great kit. Easy installation, high quality, Great value for the cost. All fittings are leak free seven months after installation.

Works awesome! Zero leaks, super easy to install. Very pleased. Been a few months now.

I needed an air system in my shop, I wasn't willing to spend on a system like rapid air. I bought this hoping it would work. It does work well, it's not the easiest system to use due to the type of piping but it's not terrible. I had a small leak in one of the fixtures but it was easy to fix. So far so good, I'm happy with the system considering the costs.

I don't usually do reviews but I am so satisfied with this product that I needed to write a review. It arrived early and it went together exactly as it was supposed to. No missing or defective parts. Took about an hour or 2 to get it up and running. No leaks at all. Quality of the materials was great. I didn't need all of the tubing but everything else was great. Plan your layout ahead of time and this was really easy to do.

This has been such a great addition to my shop. No hoses (well...not as many) to trip over now, and I've got 3 different outputs to run from. This was easy to install, and has worked great. The only caveat is that the dried paste already applied to the male ends of the tubing fittings, leaked on a few of my fittings. I thought I had them tightened really well, but still had a few small air leaks. No worries though, I just applied my own teflon tape to all the ends, and had no issues at all after that, so I would recommend taping the ends so you don't have to redo your work. Overall, highly recommended.

I must admit I had low expectations for this item when pulling the trigger, however for the cost savings vs the competition I decided to take a chance There were many reviewers complaining of leaks from various connections including the press fit connectors and the plug on the rear of the mounting blocks. I followed the advice of on reviewers and used plumbers putty instead of teflon tape on these connections and have had no leaks since installation 2 months ago The press fit connections trick is to ensure the hose is fully seated and there were no leaks there either. I have ball valve shut offs at all drops including the water filter which will be used in normal operations, however to test the installation I had pressurized the lines with 125psi and left it for a week with no leaks.There are also comments regarding the cutter supplied with the system, this cutter worked flawlessly, just make sure to place the tubing into the deepest part of the 'V' in the cutter to engage the full blade while cutting, by doing this there were no problems with all the cuts I had to make.The plastic fittings are a bit concerning going into the winter months. The system is mounted in an unheated garage so time will tell how well the hose and fittings hold up. At this point I can unequivocally recommend this to plumb a garage air system.

Very difficult to unbend the coil and not have an issue with connections. Have multiple leaking joints that I think are from coil tension. Maybe when summer comes and shop heats up tubing will relax.

Was very easy to install overhead in my shop. The included tubing cutter worked surprisingly well. Just be sure to pull back on the collar when putting the hose into the quick connectors and seat them all the way. Then a sharp tug and they're locked i tight. I would recommend some quality thread tape made for pressure systems ( I used the grey tape) but I'm sure the yellow type for gas lines would work as well. I'll be adding more drops in the future. Oh yeah be sure to get the proper brass adapters if you're air hose has 1/4" npt fittings (most do) you'll have to step down from the fittings in this kit. And you're also going to need clips to secure the hose as you route it. I purchased half clips here on Amazon, very well priced and they nailed up in the rafters easily.