GH1.25 Connectors and Pre-Crimped Silicone Cables Compatible with JST GH 1.25mm for Pixhawk 6C 6X Pixhawk 4 15cm Wires

A friend of mine gave me a couple of new Holybro Pixhawk 6x minis that he had leftover from a project where he worked to replace my aging Pixhawk 1 v2s. The Pixhawk 6x mini uses the JST GH style connectors and my original Pixhawk 1 GPS2 JST and Spektrum RC Receiver PPM output standard servo connectors would not work with the Pixhawk 6x JST GH mating connectors. So I was able to use the JST GH connectors and pre-crimped wires in this kit to make adapter cables to connect the Pixhawk 1 GPS2 and the Spektrum RC Receiver PPM output to the Pixhawk 6x corresponding JST GM mating connectors. Worked great, highly recommended to make custom JST GH connector cables.

Oh the things you can fix with this. Lots of wire and clips. Well made and convenient.

Great quality products for my project. It comes with a case the is also nice and keep everything organized.

I used this kit to extend the wires on some of the components in my drone build. The wires and connectors worked great for my GPS module and receiver module. The wires and connectors seem to be of high quality with sufficient gauge and supple insulation. Works great for my purposes.

Nice kit. I'm glad it came with tweezers since you sometimes need to press the wires into the connectors. Unfortunately, as soon as I plug any of the connectors into my flight controller or sensor the locking tab immediately breaks off.

These are all the most common connectors, pretty much pre-made and ready to use. This cuts a lot of time off of using take-out parts from printers, drives, and other equipment in any of your own designs. Great for prototyping and DIY projects.

Large assortment of premade cables made this a very handy kit for a drone project.

You need MX1.25 not GH1.25. Kit is entirely useless to me, but all the parts seem quality. The silicone wire is nice.