Onlyfire Stainless Steel Burner Tube Fits for Weber Q200/Q2000 Series Gas Grill(Replacement Part of 69956/60041/41862)

Easy to put in. Be sure to clean all the inside walls of the grill before you put in this new burner tube.Note- After 20 years it was time to replace my old burner tube that had cracked open on one end. The old burner had a screen that attached all the way around by the end plus a steel semi circle clamp that went over this screen. It had a screw hole so you could move the clamp and adjust the airflow. I was a bit apprehensive at this new burner as it has a built in screen on the bottom and no adjustment. It works perfectly. In fact I also replaced the grill cooking grates with the Uniflasy 7645 Cast Iron cooking grates. Its in two pieces and provides clips to put on both side. Fits perfectly and now this grill is like new!. But I believe they will last another 10 years or so with proper cleaning. This grill cooks perfectly and is much faster than the original. Most likely because the grate was quite built up on the underside from so much use. Highly recommend- Would buy both of these items again

Great value and perfect replacement for a worn out burner for my Weber Q2000 gas grill. Despite cleaning the holes for the old burner, there were still a lot of dead spots. This made my grill almost as good as new. Easy to replace, but be sure to use the existing nut and bolt since this comes with the burner tube only.

This worked great! I had a new weber q where the flames would barely come around the burner, weber sent me a new regulator which didn't help. I gave this a try and instantly worked. Install is very easy with one screw. The hole for the gas to pass through is smaller on this one compared to the genuine weber, I like it because it pushes more gas through the tube. I'd definitely buy again!

This replacement for the original burner tube on our Q220 grill fit perfectly. The old one was out and the new one was installed in less than five minutes. The new tube does not come with the mounting screw so don't lose/discard the original. We now have clean, even flame.

The aftermarket burner was easy to install seems to work well. I noticed that there are fewer but larger flame holes the the OEM part. I cannot tell any difference in the heat control. It makes me wonder why Weber would go to the expense to manufacture a burner with more smaller orifices. 🤔

Wound up returning this item, I didn't see listed size, so it didn't fit the grill I was trying to fix.

This item cost a lot less than the other burners listed. The quality seems to be just as good as the original. The flame is even around the entire burner and it’s a nice blue hot flame.

Perfect fit for the Q2000. 2 minutes to install and cook. Runs like a new grill.