Pyle Portable Dual Laptop Stand - Standing Table Holder with Bracket Arms, Adjustable Height and Ergonomic Design for DJ Mixer, Sound Equipment, Workstation, Gaming and Home Use - PLPTS45

This stand is very athletically pleasing and it works so well I am able to get additional space on my desk with both my laptops lifted up. It has really changed the look of my desk and I love it so much! I only wish I would have purchased it sooner but I really love seeing it so awesome every day. It is solid, sturdy and great looking. I really like this stand! I hope this helps!

Radio, Club, Festival, or home studio setup this Pyle unit will satisfy for many styles and needs. Durable. Solid design.

It is easy to assemble, easy to adjust, and it is sturdy enough to hold two of my 17 inch laptops. The top laptop shelf can be placed high enough that my third 17" laptop can easily fit underneath it.I would have given it 5 starts except for 2 issues that were easily corrected.1. The bent section of metal on the flat metal bars that the laptop sits on, that were designed to keep the laptop from sliding off the front of the unit, failed to work for my HP laptop. The HP laptop has a rounded front edge and it would ride up and over the metal tabs. I flattened out the factory tabs and re-bent them about 1/4 inch longer and now they hold the HP laptop in place. A simpler solution, for someone without access to the tools to re-bend the metal bars could be to just put something slightly taller in front of the tabs.2. As others have reported, the computers didn't sit level, the ends of the computers that are farthest from the pole are lower. I shimmed up the metal bar that supports the laptop on the far ends with about 10 or so mm of washers and replaced the bolt that holds the metal bar with a longer one (to compensate for the thickness of washers). Now the laptops are level.Overall I'm very pleased with this stand. I now have simultaneous access to all 3 of my laptops.

Holds a PV10AT & ASUS 17in laptop just fine. I use it all the time, the only issue I've began to have after a year of heavy mobile use 3 of the knobs are wearing out. I tend to over tighten them, not their fault! Looking for replacements, all metal ones but no luck so far.For my uses it's perfect. I run 2 hosts at every event and there's an 18 in difference in our height. I run sound and the other runs the software for karaoke and trivia. I can have the mixer at my lvl and laptop at hers. HUGE PLUS for me also:Leave the bottom knob by the base loose (not off) and the stand rotates freely! If i get bombarded with singers by the DJ booth I'll just spin it around and host from the other side of the booth and she still has access to the laptop on her side with the twist of a knob.WAY BETTER THAN THE VERSION LISTED ON SWEETWATERS SITE TOO!

Nice idea, but trash execution. All the fittings are *so* much bigger than the support pole that there's an incredible amount of slop in the joints, so everything is hopelessly slanted. Even the fitting at the base, which is closer (but also a different diameter than the other fittings, for some reason) couldn't be shimmed well enough to remain properly perpendicular. They really didn't care when they sent this out of the factory...

Great to set up laptops and sturdy. Adjustable as well to make it easy to move to different areas on desk.

Very good and sturdy stand. Well built! I use it for my Ableton Push 2 and Presonus Faderport 8. Works flawlessly. Also love that I can adjust height settings and angles.

This stand is amazing. I use it to hold my laptop and my portable microphone system. It works so well and I could not be happier.