LED Side Marker Light Kit and LED Cab Roof Smoke Lens Light Kits For 2003-2009 H2 Smoked Lens Amber/Front Red/Rear Replacement (Clear Lens Side Marker Lights)

Very easy to install except the passenger rear. The best way is to remove the pin that holds it to the body. Doing so provides enough room to comfortably switch out.

Lights are still performing as they should after 1.5 years. They are great quality in my opinion. Beware that does take some time and skill to do the back marker lights. They are not as simple as doing the fronts. I love these lights and they are way brighter than the OEM side markers.

I love these lights. Installation was easy, and an exact replacement. I couldn't tell which was red or yellow because they're clear, but the electrical connections are different so you really can't screw this up! This is a nice upgrade to my H2 SUT. They've been on for a about 4 months now and they still look amazing!

These are illegal to install on a Hummer Truck, theres no DOT STAMP, and there’s NO Reflector from the lens, so if your parked on the street no one will see your truck from the side, and if you get in an accident and they find out these are not dot approved, your getting the ticket ! Its the Law !

Good product as described

Hooked them up and now the front 2 do not light up. The wires came right out of one of them. I cannot fix it. Very disappointed that the wires disconnected from the bar. Now it is useless.Addition...Contacted the seller about the problem. They sent us 2 new ones. Sadly within a month they did the same thing. Would not recommend at all!

You cannot connect the rear marker lights unless you remove all the rear cargo panels.It took me hours to get the rear panels out. Eventually I just cut and spliced.Nothing easy or simple about installation.

I order the set of LED side marker lights to the front and back to my 2005 H2 Hummer SUT. I have own my Hummer for 13 years since 2007. And I have only had to replace the front amber side marker signal lights twice. My inspection was out at the end of the month of October of 2020. My right front amber side marker light was not working. I know from the past that GM charge over $110 for just one side marker. No telling what they want for one now? I got on Amazon to see if there were any replacement much cheaper? I found these clear and gun smoke LED side markers much cheaper then one GM part. The 2 Amber/2 Red side signal markers under $100. After I replace the bad one on my Hummer it cancel out the signal to my other good working GM side marker turn signal lights. I was planning on just using just one of the amber lights. And use the others later if another one of the GM lights goes bad. But only the new LED right front side marker would work. But the LH red rear marker would not work. Neither would the front or back side markers on the RH side were not working either. Just installing one new LED side marker light would cancel out all my signal marker lights not to work at all.So I decided to replace the other amber working GM part that was working before I installing the new LED light I purchase from Amazon. Now both side markers upfront only would work. But the two red side markers in back were still not working. I know it's not Amazon fault why these LED lights will cancel out the signals to my other GM side marker signal lights. But they should warn buyers what problems I had to deal with? After I remove the rear red side marker lights to the frame of my Hummer for the first time. I notice the wire ran somewhere behind the bed liner or wherever thru a passage? I could not disconnect the rear lights. So I only found one video on You Tube that someone had the same problem I was facing. Unless I knew where to look to disconnect the red female side marker behind the bed liner or inside the cab our under the vehicle. I would have spent hours searching for the female disconnect harness. A job you should not do if you only have about a hour before driving to work. And don't want to take a chance in getting a ticket at night.So I decided to cut the male connectors to the good and bad amber side markers upfront. And cut the red side marker lights wire from the rear of my Hummer and not the good LED light. But the wire coming out of my Hummer to the red side marker. Then splice the male connectors to the cut wire to the red marker and connected the male and female connectors together. So now I won't half to waste my time looking for a female connector behind the wall inside my Hummer. And the male and female plugs both connected just fine before cutting the wires.I wish I could find a work shop manual book on a 2005 H2 Hummer in a store somewhere? Or know where to look to pull up a diagram on my side marker lights or to anything else. But in the You Tube video someone cut the new GM marker lights before this guy owned the Hummer. I though that was foolish to cut a brand new marker light. What if it was not working? How could someone return it if you cut a brand new part? You Can't! So I only cut the male connectors plugs to the amber front lights. And splice it to the red cut wire markers lights coming out from my Hummer. Blue wire went to the red wire for positive. And the black wire to black wire for negative. And I can always rewire the good working GM markers light plugs back. If I wanted to go back buying outrageous GM parts.This is why am only giving three, (3) stars for the new LED lights were not compatible working with the current General Motors parts. If I did not order the whole set for front and back. I would have not been able to fix's one bad signal GM side marker light by buying one set. But I will give the manufacturer a five, (5) star for making a very bright LED light. They actually hurt my eyes up close for their brightness. These lights would be the way to go if I ever needed to replace just one front or rear side marker lights again. After I had to install all four LED lights on my Hummer. Now only time will tell in how long they will last?