ACANIIFor 1999-2004 Ford Super Duty F-250 F-350 Truck Excursion Conversion Chrome Headlights Headlamps Set Left+Right

I was having problems with my 2001 F-350's headlight and turn signal assembly not holding and drooping. So, I purchased this unit and had it professionally installed. The look really good and work well. I do recommend this unit.

Instructions for cutting the header panel were clear, fitment of the light assemblies were spot on. They included the h13 headlight bulbs which i did not expect. Only thing after installing tgem, was the marker lights did not fit in the holes. Had to get different light sockets to fit from stock, but that is not the manufacturer's fault. Love the lights and how they make my truck look!

So our 2003 F350 had the square headlights. which had missing parts this order got us updated. Just had to cut out a section to make them fit. The headlight bulbs it came with are dim so we ordered the H13 Leds at another place. Otherwise no complaints here the front end looks great. All one piece.

The lights look great when they are done. So I guess it's been worth it. And NO CONDENSATION. I hate it when new lights do that.If the lights are in an older truck the fiberglass sub support has to be cut out some. They give you nice color directions for that. I used an oscillating tool (Fines tool, vibro tool) to cut mine. It wasnt too bad but that dust is nasty stuff. Wear a mask. Save your lungs.HOWEVER!, the light connectors were wired backwards. It seems I am not alone in that issue. That was just kind of a pain. Just plug them in and test them before final install. If you find that they are backwards. i.e. low beams are high and high beams are low, I've posted a couple pics on how to de-pin the adapter and then just re-plug the wires back in. It beats cutting wires for sure.1. Find something like a small seal pick.2. Stick it into the connector to push the little tab back a little and pull the white wire out.3. Do the same for the red wire. Leave black. It is the ground.4. Make sure the little tabs are bent out a little so they will grab the connector again.5. Re-insert the white wire where red was.6. Re-insert the red wire where white once was.And your done. It's simple but it's something I dont think you should have to do. It's just annoying. But anyway. Lights look nice. Work great so far. I'll still give them 4 starts because they are sealed properly.

Good product was hesitant to install due to the cutting but was not bad at all. Did not have to drop bumper looks good product will update in a few months for longevity. Also will need to buy the hardware which was cheap everything for 10 bucks or so. Also will need to buy straight side lamp marker socket. Dorman 645-550 Marker Lamp Socket...

First of all, the high beams and the low beams are switched, you have to switch the wires in the harness they give you. Very cheap harness and plugs, after 1 week the connecter started burning out. All the materials just feel very cheap and I wonder how long these are going to last.

These are factory ‘05 headlights! Not conversion headlights! You will either need to chop a good bit of material out of your truck or buy a front support off of an 05-08. I decided to cut (bc i’m cheap lol). Best tool for the job is an oscillating saw in my opinion. WEAR A MASK! That fiberglass dust is no joke and very bad to breathe.Also I read that others had to switch wires on bright/ normal so I did and ended up having to swap them back. The turn signal lights don’t fit that well so I recommend buying the pigtails for the 05-08 model.

There's quite a bit of cutting required, but it's worth it. The directions were clear and easy to understand. They look great!