Ultimate Arms Gear5" Bolt on Picatinny Rail for Hand Guard and Magpul MOE Hand Guard

So, I got it and it fits just fine. Be aware, this is designed primarily for magpul MOE furniture and just so happens to fit m16 carbine length handguards. To put on an m16 guard, you'll need some washers. 1/2 work well and I had some m10 washers laying around that were perfect.It won't line up dead center of the m16 guard either, you'll have to move it closer to the front to get all three holes to line up, but they will. When you tighten it down on the m16 guard, make sure it's not canted by manually holding it as you tighten the bolts. It only takes a minute or two and comes out rock solid. Make sure you locktight the screws too. Screws of this size tend to work loose over long periods of time.If you need a nice, affordable option compared to entire modern handguards, this is for you. Very easy to install, and very lightweight but sturdy.

Fits my Delton Mod 2 Sport AR-15 perfectly. Installed on the lower M4 type handguard so I could attach a tac light, ez pz. Nice rail at a very good price, includes 3 sets of screws & nuts. Make sure you remove the heat shield before installing, after installing you can put the heat shield back in. Watch a YouTube video if you need to.

These work but will need to add a washer head is to small

Just get a pack of washers I don’t remember what size

I kie this is a 5 inch rail. I was hoping for a rail to directly bolt to the 3 inch on center swivels on my B14R. Luckily I have a drill press so I was able to use one of the swivel bolt holes and drill two additional holes in the stock to mount securely. The screws that come with it at 4mmx.70 pitch and very short. They are designed for mounting to a thin rail. I went down to the local hardware store and picked up 3 4mm machine screws 25mm long and used the flush mount nuts that come with it.Used the rail to mount my bipod and went out target practicing. Very solid.

The screws and nuts are entirely to small. They just slip right through the hand guard. Not worth the money

the hardware is not large enough and pulls through hand guard. I had to carefully remove the heat shield, add my own stainless flat washers and use the included hardware to assemble. I put the heat shield back after assembly. Use the largest flat washer you can fit into the hand guard to keep the rail from moving around after use.

This fits perfectly on my rifle length plastic clam shell type hand guard . Placed it on the top for a light mount and has held in very well. Good metal construction and perfect for the price. Highly recommend