White LED Interior Light Kit for Toyota 4Runner 2003 2004 2005 2006 2007 2008 2009 Super Bright 6000K Interior LED Bulbs Package + License Plate Lights and Install Tool

Nice led lights.brightness is perfect

Compared to the factory interior lights this is like full on daylight

Make sure to install them right lol made a mistake thinking I know everything but these are exactly what they’re supposed to do and look and work great

Put in these light and they’re very nice, only issue I had was breaking one of them for the dome lights because the end just broke off, other than that I like them. And some of them just needed to be flipped to turn on.

Easy install, helpful instructions and tool with one point of clarification….. The “Footwell” lights are the ones on your running boards not internal in the vehicle. Very bright white lights. Do not recommend attempting installation in 20*F weather outside.

Exelente

07 sr5 toyota 4runner (4th generation). Swapped all lights but glove box, since I have no idea how to even go about that. (has like this shield thing that's recessed in a hole. Don't know how to remove the sheild to get too the bulb it hides underneath) plus have 4 spare as I think they replace the ones the limited comes with on the steps.The difference is insane. I still have factory tint which isn't very dark to begin with. And when unlocking, the 2 dome lights light up the entire inside, door lights are super bright as well. As are the license plate lights.Didn't expect much as in store, say walmart or target. It cost about this much just for 2 or 6 bulbs. Not entire interior. Would highly recommend.I broke one dome light upon removel. As I didn't know you pressed a tab to remove it. Instead tried to pull straight down. The other lights take a little finnesse with your fingers, to remove, but it's possible. Sucks though as no way to turn them off when door is open. (especially the door ones) so those were a little hot to remove. The vanity mirror wasn't exactly easy, nor hard. But the cover remover they give you with this set, is far too large. So I used a mini flat head to do those. Broke tabs on both. Since they're not exactly easy to remove in the first place. No matter how gentle you try to be. Also polarity sensitive. So if it doesn't light up one way, simply pull out again, and turn around. All work, all are super bright.Factory was 'ok' but where I live. Gets super super dark. And even with those lights, they appeared dim. Lots of blind spots. Hence the upgrade. These, get virtually everything. Definitely worth the $20, especially when it comes with cover removal tool, instructions (in ENGLISH! That tell you exactly what bulb goes where) for the entire interior (step lights on the limiteds), and license plate/glove box. As for longevity, to early to say. But they are definitely worth the money.I like em. :)

The aluminum 194 bulbs are about 4mm to 5mm too long. Any space that has a tight height fit will not work unless you are willing to modify it. In the picture, the top is a modified bulb to fit into the map light. Below that is the stock 194 bulb, the bulb supplied for the backup license plate lights, then an unaltered 194 from the kit. The length difference is just alarming. The license plate lights are the type with resistors to trick the car into not thinking the low power of the LED is a burned out bulb. The light output from this design is low, and the heat is high. Not a great deal. The light output is not bad. The dome lights fit better than I expected and are bright.