AHT10 Digital Temperature Humidity Sensor Measurement Module High Precision 1.8-6.0V I2C Communication Replace DHT11 SHT20 AM2302 (5pcs)

The media could not be loaded. I have only rated this 3 stars because there is little in the way of needed information for someone who actually wants to use it in real circuits. The video attached shows the schematic (I really don't get why sellers don't provide the schematics.) The XC6206-3 is a 3.3V output voltage regulator. The Vin of the circuit needs to be approximately 100mV above the 3.3 volt output for it to work. Connecting Vin to the 3.3V of any processor board would likely result in, at best, unreliable function or more likely the AHT10 not communicating. Providing 5V to Vin seems to work fine. As can be seen, there are pullup resistors for the I2C lines, these may be adequate if the processor board has none on the I2C pins.

From the AHT10 datasheet "Only a single AHT10 can be connected to the I2C bus and no other I2C devices can be connected". Recommend using an AHT20 instead.