uxcell 2 x 180W 3-Way Audio Crossover Filters Frequency Divider Speaker 850/4800 Hz

Used these in an old set of acoustic research series 660 monitors, their crossover frequencies seemed to line up very nicely with GRS's cheap paper woofers and cheap sealed mid ranges. Also used GRS ribbon tweets as a finishing touch and the one "splurge" of the extreme budget project. Also added a 10" grs high excursion sub.They sound and image fantastic for running on a cheap class D bord, not as good as the klipsh in the living room running on A/B, but they sound fantastic for the money put into the setup, and the xovers are performing admirably if i had to say so. Gonna have to build a small dampening chamber and find a suitable full range to do the job of the grs sealed back though. Its absolutely the systems bottleneck.

I'm using these for the top end (tweeter) position on a vintage homemade set of EV based PA speakers. These crossovers sound super clean and clear! I was looking to cross them over at 5k but 4800 is close enough for me. For the money they're hard to beat!

Speakers sound really good. Quality components. Simple to use.

I have my Teac speakers working really good now. One coil mounts were broken which snapped the wire into. I solder on a small piece, drilled through the solder and re-solder it back. I had already returned some damaged crossover that took four weeks to get. I didn't want wait any longer. The repair worked fine. I watched a couple movies and bass is great! Would recommend to anyone wanting repair old speakers.

Upgrade for 39 year old Infinity ES-103, easy if you possess basic solder skills, the board is clearly marked and the sound is great, money well spent.

I bought these as a temporary cross over on some 3-way tower speakers. I do not think the values of components match what is written on the specs.Overall it idk worked but gave me a big hole in the mid range and a huge peak in the highs.I took them apart and tested the inductor and it was quite far off of advertised I also think some of the capacitors were not the correct values as well.I think you could order better parts and build something simple that would probably do a little better for a little more money.I would recommend adding another resistor to the tweeter side this will bring the highs down a little you could add this in the positive connection from the speaker wire to the speaker driver terminal.

The media could not be loaded. I was looking to replace a 10 inch speaker on a set a 40 year old speakers. to my surprise no crossover inside. decided on this part reading the reviews. watched a few basic soldering videos on YouTube and decided to give it a shot, I got better at it the more connections I soldered. hour and a half later I hooked them up to my old technics receiver and wow! The separation between the three speakers is nothing short of amazing. The midrange was nonexistent before the crossover was installed. The Tweeter now is loud and clear. Pleasure to my ears.

I had replaced my JBL speaker crossovers previously (a different product) and was not pleased with the result. I decided to give it another chance and bought a pair of these. Wonderful results. Bass is back and treble is crisp but not overwhelming. I am very happy with the experience overall.