PrimoChillSystem Reboot - Cooling Loop Treatment

I was an idiot and didn't rinse out my brand new custom water cooling loop before filling it. So filled it with distilled water for a week waiting on my EK Cryofuel. Drained most of the distilled, but the EK Cryofuel in and immediately got a cloudy mess. Took 2 weeks to turn somewhat clear, but left the blocks with a white film on them, my Corsair soft tubing went a tint of yellow. Flushed the system, replaced the soft tubing with EK tubing, then did a 24hr rinse with this stuff using method 2.24hrs later, I'd say 90% of the white film is gone. I flushed this stuff out with 3 rounds of distilled and now I'm back with some fresh EK Cryfuel and so crystal clear liquid!

Use this to Flash out my old system then install the blue color and everything looks good

This is by far the best cleaning solution for my custom loop I have used. My system had a small amount of growth and buildup in the CPU mono block. It was almost completely blocked up after almost 2 years of use. (Yes I know. I should never have let a loop go that long. But after about 2 hours this started to help the flow and after the full 24 hours of running there was very little buildup still stuck in the fins. I highly recommend this product. Just make sure you fully flush out the system.

perfect, using this to clean my water cooling set-up to change a new color

If you use this for regular maintenance, I think it should work well. On a system I had running for a year with orange dye, I finished two bottles following all instructions, but still ended up disassembling the loop to manually wipe the stuck dye off the blocks. I also had to use hot water and vinegar on my radiators and still saw a lot of orange come out.Morals of the story: don't use bad dye (or any at all), do maintenance more often.This product works for normal use and regular maintenance. It is by no means a miracle solution.