E-Z Slide Boat Trailer Slides and Bunkenders for 4” bunks – in Black or White

I finally had a chance to put these on my boat. They worked great. I have a 20 foot aluminum boat with 4 running boards . I bought 2 sets. Time will tell if they last long .Warning , don’t unhook the bow until the boat is close to the water. The boat slides off very nicely .

They were a great addition to my trailers bunks . Very quick & easy to install. I just launched my boat at the ramp & parked the truck & trailer. I’d brought a tape measure & a driver & drill with me. In a matter of minutes it was done. The boat winches much easier & those side to side adjustments are much easier because of the plastic glides.

Every boater should have these on their trailer.really makes a difference when hand cranking the boat up.should have had these sooner.

These pads definitely made the difference. 100 times easier to get the boat off and on. Be care putting the screws in. The head of the screws will strip out very easily. They are Phillips head but the stainless is very easy to screw-up. But I would recommend them.

Purchased to cut down on labor on electric motor lakes. It always a challenge pull boat onto trailer when I can't use the gas motor pull up onto trailer. This made the pulling up much easier. The screws are stainless screws. Most marine screws are soft metal. ** ->So drill the correct size pilot hole!

Much smoother than bunk carpet and makes loading and unloading super easy. I put these on 2x4's coated with fiberglass resin to waterproof them so now they don't have wet bunk carpet sitting on them to rot the wood. If you have a habit of unhooking your winch strap before backing down the ramp I'd consider not doing that if you install these. It takes very little effort to move a boat with these on the bunks so it could cause your boat to slide off while backing down or pulling up the ramp.

Bought these for my 14 foot Jon boat trailer and they work well. For lighter boats you can space them out farther too

These are a lifesaver. There are many boat ramps that I have not been able to launch from due to low water. Now I can shove my boat off or load it with ease regardless of water level. If you are a jet boater looking to launch at shallow boat ramps but don't want to invest in roller bunks, GET THESE. I have tried some of the cheaper knock offs available on amazon and though they look the same the knock offs lack the slickness that these have.

Works great, much easier to load my boat

exactement comme la description

très bien s'installe facilement, très efficace répond vraiment à mes attentesPS: garder le bateau attaché à la prou pour la mise à l'eau car le bateau glisse facilement

The boat trailer that these were installed on is high , they made for much easier launching and loading .

Very pleased with these sliders, I simply purchased two new 2 x 4, covered them with urethane on the top sides only to allow excess water to evaporate from the bottom and installed the sliders. I had no issues when removing my boat from the water and expect these to outlast the trailer.