INSTRUCTIONS: With the new switch plugged in, turn key in ignition to on position, and pull up on the drivers window button until the front driver side window is completely closed, and continue pulling up for 3-5 seconds. The auto function of this button is thus activated. After verifying your auto function, remove and reinsert key into ignition. Turn to on position, then press the lock button on the key, then turn the key back to off. Quickly repeat this operation five times back and forth. The remote lock button functionality is thus activated. Do not completely reinstall the window switch until you have verified your new switch and remote lock key fob is fully functional. If after several synchronization attempts your remote lock key fob is still not functional, it means the frequency of the receiving module is different from that of your Accord (This occurs in about 1 out of 10 vehicles with any aftermarket switch version currently available). Using the radio module from your original switch will solve this problem (assuming, of course, that your original switch was still functional with the remote lock key fob). The radio module has the FCC frequency information stamped on it. Both modules have a center screw that must be removed first with a 0 or 1 bit size phillips head screwdriver. After removing the screws the module units can be removed by placing the screwdriver in the tab hole which can be seen at the bottom right of the module and carefully levering up. The module has a small connector that plugs into the switch circuit board. Install your original module into your new switch by alligning the connector with the plug in and push in, then fasten the screw back in. This entire operation with take less than 2 minutes at most! In rare cases your original module will still not sychronize in the new switch. Call us for further simple solutions should you encounter this problem.
Trustpilot
1 month ago
1 week ago
