1.5" Wrought Iron Patio Furniture Feet Caps (24-Pack), Chair Leg Floor Protector Replacements for Outdoor Metal Tables and Chairs

these work great for what we needed them for, used them on feet of our metal patio chairs

Thay fit and look just like the picture nicer than what table came with ...

Let me start out by saying these end caps are virtually identical to the OEM caps that came installed on the furniture, that is what I was looking for. I would have liked them to be a little thicker in the surface that wears but, that would have made them even more difficult to install - see below.Installation was a learning experience and I am posting this review primarily to help others learn from my efforts. I read with interest all the reviews about the end caps and techniques to install - prying in with screwdrivers, squeezing in with channel lock pliers, beating in with a hammer and a block of wood. I tried each and every one with limited success. What worked for me the best was to buy a 99 cent worm screw clamp at a hardware store (auto parts store would be fine) that would open to 1-1/2 inches, place the end cap in the worm screw clamp and tighten it down until the edge of the end cap were deformed smaller and drop the worm screw clamp and end cap assembly in very hot water and leave it in there for 3-5 minutes. I then fished it out of the cup of hot water with a screw driver (be careful, it is HOT, I wore gloves), immediately remove the end cap from the clamp (be careful it’s still HOT), placed it into the recessed area of the furniture where it belongs and pressed it in/down firmly/hard, light tapping with the hammer if required. If it doesn't pop right in, flip the furniture over so the end cap is on the floor, lining up the end cap with the recess and but weigh on that leg of the piece of furniture. A few times I had to re-clamp and re-heat the end cap and try again. This method worked well for me and I installed 16 end caps fairly quickly. I would buy again, it is what originally was installed on the furniture, installation will go much quicker next time, no more rust stains on the floor.

This product meets my needs perfectly for replacement sliders on my wrought iron patio furniture. They are extremely durable and while snug inserting they stay in place until worn and ready for replacement. Great product.!!!!!

Thanks

Very hard to install has no helpful bezel to get started in the leg.

I am happy these exist. I needed them so my outdoor furniture doesn’t scratch up my new deck. The fit needs to be tight so they stay in place. That means they’re a bit difficult to bang in with your hammer so that all edges are inside the metal. Some said that soaking them in very hot water softened them up to make it easier.I tried that, but it only helped a little. Eventually I got all 16 in place. Nonetheless, I recommend if you need them. They work great. None have come out. Make sure you order the right size.

We have purchased these before from the same company with no issue. However, they have changed the design or something because they are next to impossible to fit onto the bottoms of our wrought iron chairs. Can’t return them because too many were damaged trying to fit them to the chairs. Really disappointing. We will have to buy from a different company and hope theirs will work better.