IQShieldScreen Protector Compatible with Apple Watch Series 9/8/7 (41mm)(6-Pack) Anti-Bubble Clear TPU Film

These are great. Won’t last forever - have to change it out every few months but it protects your screen and you won’t really even know it’s there. Installation requires patience. Don’t try to install this if you’re short on time. Just keep on pushing down the edges over about a period of 30-45 minutes.

I usually trust IQ Shield products but this one was disappointing. I’ve already gone through half the pack and each time the screen protector won’t stick to the edges. I’m usually very patient in installing these and will wait a few days before I wear my device. However, the small little bit that sticks out will keep gathering debris and dust underneath and eventually the whole thing will peel off if I accidentally get it caught under my clothes or bedding.

While these are a little bit of trouble to install, they work well. I just had to change it due to the fact that it was peeling up on one edge. It did last several months though.

I have used IQ Shield in the past, when I had a FitBit Sense. I now have an Apple Watch, and I stupidly waited almost a month after getting it before ordering a screen protector. Unfortunately, my watch got a pretty large scratch before I could even get these in. One of the big perks of these screen protectors is how well it will hide a scratch once you put it on. I can barely even see the scratch now, even though it was pretty deep. It will completely mask light scratches. Couple that along with protection against future scratches and IQ Shield has won me over, despite the slight difficulty applying these protectors. Maybe difficult is deceiving, because it’s not so much difficult as it is time-consuming. So, word of warning, applying these protectors requires a lot of patience as it is a wet application and you will have difficulty keeping it from sliding around while simultaneously removing the air bubbles. The very last step will be to get the edges to stick down. My advice is to get the main part centered and all air bubbles removed, and just let it sit for several minutes before even attempting to push the edges down. Instead of pressing and holding, I lightly pushed around the edges a little at a time. Don’t give up, just keep lightly pushing around the edges and they will eventually begin to stick. Once they edges are down for the most part, THEN go back around pressing harder and holding a little longer.Once you get the hang of it, it will get easier each time. And yes, eventually you will have to use the others that are included in the box, because these are means to lost forever. But for the price, you get 6, and they will last you quite a while unless you are incredibly hard on your watch.

The size was perfect and it adhered well to the curve of my watch screen but it not only had little bubbles but also smudgy looking…not super clear like the ones on my iPhone. I watched the video, followed the instructions and tried again with 3 of them (thinking it must be me) but it always looked the same. It’s okay if you don’t mind it being noticeable.

These adhere well and are genuinely hard to tell they are even on the watch. I am pleased with my choice.

It was really hard to get it to stick to the curved edges of the screen. And then every single one started peeling within a few days at the most. They are pretty thick as well. I ended up ordering the LK ones to replace these and they are so much better.

These screen protectors go on well and do a great job of protecting the screen. There are also six in the pack, so plenty of replacements for when they inevitably need replacing. Great product!