Danco80020 Universal Metal Diverter Canopy Handle, Large, Chrome, 1 Count (Pack of 1)

Easy to install and works fine. Great product for the price.

Saved me from buying a new complete valve.

The knob on my old faucet broke and this worked perfectly. It's a little hard to turn when it's wet, but it does the job and was so easy to install.

Wasnt packaged very well it was open on arrival but no damage and it worked as it should its decent quality metal and it works for now until i can replace the whole fixture

Excellent replacement part. Would buy again.

The sizes didn't match up was to long to going out ward and not short enough for not use with stem need a wider one also but still works for the moment

The original (unknown manufacturer) handles were not comfortable in hand, but the spline on the valve stem was impossible to match with any replacements after searches in the usual home improvement stores and online.The clamping 'vise' adapter included, solved this problem nicely.The finagling was as follows:The end of the original valve stems did not extend past the trim tube that conceals the stem. This presented a problem in that the screws to tighten the 'vise' adaptor were not accessible when placed on the splined end of the valve stem.This was remedied by unscrewing the trim tubes.... then installing the 'vise' adapter... then reinstalling the trim tube.When it comes time to attach the knob to the stem you must align the notches on the 'vise' adapter to the insideof the knob.Then install the knob keeper screw.I had to use the long spacer that is included to keep the knobs from touching the shower wall.In order to get the long spacer (if used) aligned properly to the 'vise' clamp and the knob, insert the proper long keeper screw into the knob and spacer with the spacer aligned inside the knob.Then align the other end of the spacer to the 'vice' slots, and then tighten the knob keeper screw.There is only the one spacer included, so the instruction to choose the best spacer make no sense.If the spacer length is too long, I think cutting it down to size with a hack saw would work, but the he length of knob keeper screw would have to be shortened also.There are 3 different style long keeper screws included to use if the long spacer is used. They are each a different thread pitch, so test to see which one is correct before installing the knob and tightening.

I have a rental house and I have no idea what brand the faucet handles are for the tub/shower.Bought this to replace nasty old acrylic ones. It works!I had to use the existing screw from the hold handles as the provided screws were not long enough. Also the handle was not long enough to reach the wall but leaves only a small gap that should be fine. Not the handles fault.I also did not need to use the spacer. This works with or without the white spacer!Finally, this pairs up to be an exact match with the Chrome Danco 80019 Tub/Shower Handles so buy them together with this Danco 80020 diverter to make a 3 knob set!

Great product

Not universal, it's in the trash now as it didn't want to setup.

Not sure this item is very universal. Grip is not good at all either