OTC 6541 Slide Hammer Pulling Hook

It work ,I had a stuck on bearing race this worked on my slide hammer Four sacks is all it took

Look like it'll work better then original type thar comes with kits

Haven’t put it to use yet but it fits well with mini slide hammer which is half of what I was looking for. Nice to have for doing exhaust clamps on my 7.3 powerstroke diesel.

over all the tool will do the job. i actually built one because this one was taking forever to arrive.that being said i will use it some day, but i am a little worried i may break it just by dropping it to the ground.i gave 5 over all stars because it arrived, and is not broken. I will not buy another like this

That magic attachment you need to get something to move just how you want it to. well made. Slide hammer can put the right amount of force where you need it.

This tool worked perfectly. The repair manual for a Toyota Matrix calls for using a special tool (09520-01010) with a slide hammer to remove the driver side half shaft. I initially tried to remove this half shaft with the prybar method recommended by a few folks in online videos. After squirreling around for the better part of a day with various pry bars, I finally gave up and searched online for the recommended tool. I came across this tool instead on Amazon and decided to give it a try. As soon as I had the tool, I threaded it on a 5lb slide hammer and went back to the repair. Five whacks later and the axle was out. I really wish I had bought this tool sooner.

Could not get my CV axle out of my 2011 Toyota Corolla. Tried for 2 hours, there wasn't enough room to get enough leverage to pop it out. Received this and it took me 2 minutes to get it out. Used it along with a 5 lb slide hammer.

Excellent tool that fits in the cooling fin area of most brake rotors to yank them off of hubs if they're rusted or seized to the hub in order to be machined without damage. Saves time and effort, I use this with an OTC 10lb slide hammer and in 3 months of shop usage I've only broken one, but that was pulling a 1994 RV 3/4 ton wheel hub that had welded it's bearings. Definitely a very useful tool that I highly recommend!

Perfect replacement for the lacklustre hook that came with the OTC stinger slide hammer kit I’ve got.The hook material is a little soft; but it’s still holding up well. It’s lilely meant To be a little softer as it’s better for it to take the wear/damage vs the component or part you are removing.

long hook much more than expected very good for work to be done with it very happy

Seems to be well made. Happy with mu purchase.