🔋 Keep Your Generator Running Smoothly!
The WENGNA200 Magnetic Oil Dipstick is engineered for precision, featuring M20-2.5 threading and a robust magnetic tip that captures metal shavings, ensuring your WEN GN625i and GN875i generators operate efficiently. With a no-spill rubber seal, this dipstick is designed for hassle-free maintenance and extended engine life.
B**J
Great value
Can confirm that this fits a Duromax 440cc engine. Has marking lines on stick also. Seals just fine.
S**Z
Works really welll
The big head
S**T
Perfect for GN875i Generator w/420cc Engine - Use for Break-in and Beyond
Always hard to tell the size of a product from photos in an Amazon listing and this is listed for multiple units. This WEN product that is much better than the original plastic dipstick. I will use it for the 8-hour engine break-in period to scavenge metal particles and also help trap them during the life of the generator - checking wear metal at each oil change for trends.Not sure the dipstick is the best way to check oil level. The manual says look into the oil fill hole and if level is up to the threads (basically just before it drips out) then level is good. For break-in I added 1 quart of oil to the small amount that was already in the crankcase and that seems just right.
G**.
A must have for my Generator.
First one I received half the gasket was missing. A quick Amazon exchange fixed the problem. Its a good fit in my Champion Tri fuel 9000 watt inverter generator 420cc engine MODEL #201176.
R**H
works great
Used on portable generator. The tip is magnetized. Only wish more of the dipstick was magnetized.
S**N
Very Low Quality
Inspected part before I installed it and it looked OK. Installed in new generator and ran generator at varying speeds and load for 2 hours. After 2 hours went to change the oil and the rubber O-ring had broken. Looked everywhere for the broken piece and couldn't find it. I now have to assume it's in the crankcase of the motor. Luckily it didn't leak oil out while running. Never again will I buy a WEN product....
G**G
Fits like it should.
Fits my WEN DF875IX generator good. Another layer of protection to help generator last longer by removing small metal fragments in oil since most small homeowner generators don't have oil filter. Make sure you get correct length dipstick and compare to your original so you don't under or over fill oil.
R**N
18mm or 20 mm dipstick!
Someone stated the Wen m20x2.5 magnetic dipstick fit his hf vulcan welder. That engine is similar to my brand new Lifan 420 cc welder generator engine, the axq200a pro welder generator.Sure enough, the magnetized version I had got for it was a Wen m18x2.5 dipstick that did fit, but the m20x2.5 fit perfect to the 420cc engine. (2mm larger).Here is the caliber reading sizes, m18x2.5 =17.34 at thread od, m20x2.5=19.58.
Trustpilot
2 months ago
1 day ago
