1/2" NPT Heavy Duty Compressed Air In Line Filter Desiccant Dryer Moisture Water Separator

I've been using the mini desiccant dryer for about a year now, and it's been surprisingly good for the price. No air leaks, I can run 30+ PSI to my HVLP paint gun with no problems, even with the fan wide open. I've got it mounted just before the final regulator/needle valve at the gun. Bought some replacement beads and also you can microwave the ones it comes with (or replacements) to reuse. Very easy to open up to swap out the beads.One thing to note is that it's pretty small. On the one hand, it means the beads can get saturated fairly quickly when spraying a large job, especially if your shop is humid. You definitely need an inline water remover near the compressor, before this mini desiccant dryer or else the beads will get saturated super quick. And even then you may have to swap the beads one or more times during a big job.On the other hand, if it was bigger, it would be a bit unwieldy when connected directly to the gun, as I have mine set up. So, maybe the size is a good compromise - just something to be aware of. Overall though, it's a good product!

I finally broke down and purchased a full set of the dryer and particulate filters. I have a major moisture problem with my compressor thats nearly 30 years old now, but is still kicking. These were an instant resolve to my problem. I had a sealing issue with one of the dissicant dryer units, but sorted that out with using yellow gas line Teflon tape that is much thicker than regular plumbers tape. Otherwise these seem to work very well, and hold the pressure at 150 psi without issue. My upcoming projects will test them out from a steady use perspective, but the moisture in the air from the compressor is now totally clean and dry, and my air tools are Grateful! I would recommend these for the weekend warrior DIY use. The pro grade level hardware is for what it is, but these are great for the price.

Everything about it is poorly created. It was corroded beyond saving and poor instruction. Failed miserably

Haven’t used it yet. I need to get threaded bushing to use

Used to upgrade my home shop air compressor air supply. This system is used when spraying automotive paints. I still used an inline moisture remover as well. In the picture, it is too the far right. The first air regulator, with 3/4" inlets, on the supply line is for air tools like impact guns. The next two regulators are 1/2". I have two blowouts, one is connected to the downpipe on the left side of this picture. The other blowout is near the compressor, where the supply goes up the wall. In the picture, you can see the supply is sloped to drain the water towards the blowout valve.

Product easy to install but when I checked the specs, the temps listed in the owners manual did not match the specs given by Amazon. Amazon says it’s rated up to 140 degees F. But the manual as you can see, says 125 degrees. This is false advertising anyway you look at it. So which is right? I would say the manufacturer. But whose to know until it gets here & you read the manufacturer specs? This is very disappointing AMAZON. The very reason I would rather buy local!

I bought this desiccant dryer for the airline feeding my cnc plasma cutter. I was having issues with inconsistent cuts and short consumables life. I was concerned about the small size, but it actually last a decent amount of time before having to dry the desiccant.

Good product for the money