🚗 Illuminate Your Drive with Style!
The VLAND LED Taillights for Mitsubishi Lancer EVO X (2008-2020) offer a perfect blend of safety and style. Featuring sequential turn signals and a sleek smoked design, these taillights are designed for easy installation with no splicing required. Built to withstand harsh weather conditions, they come with a 1-year warranty and are DOT/SAE certified for quality assurance.
| Manufacturer | VLAND |
| Brand | VLAND |
| Package Dimensions | 52.83 x 41.4 x 21.59 cm; 2 kg |
| Manufacturer reference | YAB-YS-0155B-321A-L-EU |
| Exterior | Machined |
| Manufacturer Part Number | YAB-YS-0155B-321A-L-EU |
| OEM Part Number | 8330A108, 8330A107, 8330A476, 8330A111, 8330A622, 8330A621, 8330A626, 8330A625 |
| Position | Rear |
| Bulb Type | LED |
| Special Features | Waterproof |
| Voltage | 12 Volts (DC) |
| Wattage | 50 watts |
| Item Weight | 2 Kilograms |
A**Q
Highly appreciated
I ordered one day ago and received my package within 20 hours.The tail light is more than awesome.The fit is perfect, and the rest is exactly as described.If I had the opportunity to give them 10 stars in a review, I would do so as well.
E**
Lancer 2010
Excelente producto, quedaron perfectos a mi coche. Lucen geniales
R**T
Amazing customer service
I had a problem with the reverse lights but after talking with vland and everything they helped me not just to fix the problem with a defective light but sent me a brand new set. They are amazing lights and I love the customer service
W**
they were beautiful, instructions were foreign so translating was a pain
Love how sporty they look
C**S
Envío super rápido y todo bien.
Lucen super bien estos faros traseros y de buena calidad.
P**1
good looking
Liked the look, install went pretty good but instructions are just a somewhat blurry picture.There are 4 connectors that fit in the OEM bulb sockets after you remove the bulbs then 2 cable sets- they are 3 20awg wires in each set with a connector on each end... 1 goes from the hatch lid to the left outer light and 1 wire that goes between the 2 lights on the hatch lid. Both cable sets just barely fit, adding about 150mm- 6 inches to the wires would make the install much better. I used small wire ties to follow the OEM set up.Running the wire/cable through the rubber flex tube I used a piece of mechanics wire and ran it through then hooked it to the wire set and with some silicone spray it pulled right through. Then unwrap the electric tape on the grommet at the body for the left light- use a pencil or something to open up the grommet then pull the wire set through there also and connect.There is a resistor- mounted on a small pc board and some 3M tape. I mounted it on the inner part of hatch lid so it is out of the way- you get one chance to stick it so make sure you have the wires in place before you press it down.You will not use the one taillight bulb on each side so just disconnect it and I wrapped it with a bit of electric tape and wire tied them up also.100% upgrade from the original light and looks great.
Trustpilot
1 week ago
1 month ago
