2015-2020 Polaris RZR Tail Light Power Harness for Whip/Brake Light/License Plate Light

I wanted to make sure I reviewed this product because I believe the bad reviewers aren't putting it in the right spot. I have a 2016 XP-4 1000. At first I put it in the rear main plug on the driver's side, this is where Polaris splits the harness into right and left. Some of the other negative reviewers pointed out that this is a four pin and the new plug is only a three pin, they are correct. Unfortunately they gave up to quick as I did at first. Fortunately a few others that reviewed this product told us the correct location which is where the harness plugs into the tail light. These are three pin plugs and it would allow you to put in two, one at each tail light. Once I did this the plug worked perfect. This location also makes it easier to hide the wires. This is the perfect product for this application and I couldn't be happier. I highly recommend.

Worked perfectly for installing an Xprite 30" chase light bar on my 2017 XP1000. You need two of these and they go between the rear tail lights and the factory wiring. Just unplug the factory wiring from the tail light, plug in this harness to the the tail light, then plug the factory harness into this harness. Easy-peasy-lemon-squeezy. Works fantastic!

Easy to install and worked perfect. Nice way to get lighted whips without having to run wire through the frame. The whips will always be on while the vehicle is running with these, which is much safer in my opinion.

worked as intended. The red wire was running lights and white brakes. Wasn't an issue as I tested prior to crimping the connections. Bad reviews seem to be just people that don't know how to install wiring. My plug came fast, was as described, and worked perfectly. Thanks!

I bought this power harness to wire in a third brake light and running light on the back of my RZR side by side. The wire and connectors are of good quality with the proper seals to keep the connections water proof. I would highly recommend this instead of cutting into the wire harness due to the abuse we get trail riding.

This adapter works great but it must be installed in the right place to work properly. Would recommend but it should have some better instructions on where you need to put it.

Nice quick way to control a relay or a lighted whip

Worked perfectly on my 2014 RZR XP 1000. Easy install, just make sure you connect it to the taillight, not the connector before the taillight, I think some negative reviewers are not installing it correctly, which is not the fault of the seller.