10 PCS 5W 1K Ohm 5% Axial Lead Wire Resistors - White Wound Fixed Ceramic Cement Power Resistors with Flame, Heat & Moisture Resistance

Purchased 10 pack of 8ohm units. All tested within tolerance at 8.3 ohms. No signs of damage to any units. Leads are slightly shorter than the old (1960's) unit I'm replacing. These are 13/16" on each side. While the leads are also thinner, they don't strike me as being flimsy. Time will tell if they take the heat, but I have no concerns at this time.

They are as promised and will work fine.

Los use remplazando LPS de mi peavey classic 100 tubos. Elimina mucho ruido..Faciles..intalar recomiendo dejarlos un poco aislados de la placa para que no calienten la placa Electronica el calor no oscuresca la placa..del circuito....andan muy bien en mi peavey classic 100

I use these for capacitor bleed resistors. They seem well made and are within spec for resistance.

Excellent quality resistors

ceramic/cement power resistors are designed to dissipate heat. If you burn one up, your circuit is a bad design or something failed and you've got too much current flowing.if you just replace a toasted ceramic resistor without fixing the underlying problem, you'll be thankful you got a 10 pack.as a test, I did just that and one of these resistors got too hot to touch within a few seconds. It survived running over spec just fine and as is now operating in the repaired circuit 12+ hours/day.

I replaced a burnt out screen grid resistor in a 'Plexi' type guitar amplifier, with one from this purchase, and, replaced the other 3 in this amp for good measure. Root cause was a tube having a short.The leads are a bit shorter than I'd like, but I was able to make it work easily enough.

Clearly out of spec and probably why they are so cheap, but good enough for my purposes.