Gasoline Fuel Filler Neck Hose with 4 Hose Clamps,1 1/2 inches Inside Diameter Fuel Hose, Reinforced Gas tank filler hose (45 degree, 1 1/2" ID)

Just as described on listing. I love the high quality and the durability. Very easy to cut down to size and install. Came with perfect amount of hose clamps. Not a single leak and absolutely no smell. Flexible enough to install without breaking or damaging. Very affordable replacement for classic cars with no OEM available. Sleek black nitrile makes the undercarriage look newer. Perfect fit on 1988 Mitsubishi Starion ESI-R.

Tal como se indica en la publicación

Finally a product with good dimensional identification. Needed to fit the tank connection on a 69 Mustang. 2-1/4 diameter pipe. Needed the bend as the tank is going in a 61 F100 between the frame rails and this routes the filler hose off to the side to connect to the filler. I am likely going to install better looking hose clamps as these look a bit small.

Good quality, fit perfectly hose clamps were good too

Just a tip, DO NOT USE A DRILL DRIVER TO TIGHTEN OR LOOSEN THE CLAMPS. While removing my old hose gasoline got all down my arm and shoulder. I should have known better (but it never crossed my mind) but I was in a hurry. The instant I pressed the drill trigger the drill gave off a spark and my arm was on fire. After stop dropping and rolling I ended up with 2nd degree burns from the back of my hand all the way up to mid bicep. I was able to put the fire under my vehicle out after a week in the burn unit I came home and the hose survived the fire, there was no damage to my vehicle at all. Don't be in a rush and please use a handheld screwdriver to tighten the clamps. The stop drop and roll was captured on my surveillance camera *** caution*** this is really me and it is really me on fire, there is no gore shown so please don't flag the video. Learn from my mistakes.