SNIPER SKIN Baseball & Softball Bat Grip | Replacement Bat Grip Wrap | Easy Install | Durable | Waterproof | Tacked for Performance

The Sniper Skin was easy to install on my son's bat. Only took about 5 minutes to install with a heat gun. Went on smooth and easy, and it looks amazing. I highly recommend this product if you want a one piece grip on your bat with a awesome look.

This grip did not work for my daughter, it gives not additional padding for the bat. She did not like way it felt and had a hard time gripping the bat with it. I had to cut it off after one use. Was a waste of money and I couldn’t send it back. Don’t take a chance, grip tape is cheaper and more padded.

This was super easy to apply and looks great, we will definitely buy these again!

It was a little more challenging to install than I thought it would be.First, I positioned the grip on the handle. I did not use the grip strips that adhere to the bat handle underneath the Super Skin. I wanted a thinner feeling on this Axe bat. I also removed some of the excess grip from the knob area prior to setting the grip. I wanted to make sure the grip didn’t go to high up the handle and cover the ink dot.I boiled two quarts of water and went to pour it over the handle. The grip started to shrink slowly. I ran out of hot water before the grip was completely shrunken to the bat. This left air pockets, especially near the axe knob, all throughout the handle.I then trimmed more grip from the knob area. I boiled more water. While the water was boiling I dipped the knob into the boiling water for several seconds. This did the trick. The grip fit snug around the knob.I then had to enlist assistance. I had a friend hold the barrel of the bat and rotate the handle over the sink while I slowly poured the remaining hot water over the handle. This finally got the grip to fit snugly without air pockets or inconsistencies.I grabbed the bat by the handle and applied pressure around the entire grip to make sure the fit was good. All set. However, when trying to dry off the water the grip attracted all the dust off of the towel.It feels good. Maybe with experience I’ll get better at installing these. Price point is a little high, but it seems more durable around the knob, which has always been an issue for bat grips installed on an Axe.

Great concept. The grip is a little sticky after you put it on. You need a heat gun or you can take your chances with boiling hot water and a bottle cap. No thanks, that just sounded like an ER visit. I opted to try the blow dryer because I didn't have a heat gun, and it worked if you're patient. Be careful not to overheat the dryer, that's why they say use the heat gun... but who follows directions anyway. Good grip and fast way to replace a worn out one.

Somewhat easy to put on except they need a better way to figure out how much to leave at end to cover the knob of the bat. Looked good at first but gets dirty way to quick.

I have a lot of experience in wrapping bats and applying shrink wrap like products but this did not work like advertised. I used several pots of boiling water on the sniper wrap and it never conformed to the bat (New Green Easton) like it was supposed to. We heard about this product through a friend of ours that is a former MLB player/Coach and hitting instructor. We had high hopes but it didn't live up to the hype. I did not want to issue a review and wished to email seller directly but I could not find the link to do so.

Easily installed. Played maybe 6 games with the new wrap and it’s holding up great.

Looks amazing and soooo easy to put on !!!

The instructions state that you need 1,5 liter of boiling water to set the grip on the bat. After over 8 liters the grip looks ok but is still loose and can be twisted from the bat. Total piece of crap!

I did the boiling waterway, but my way in a big pot so I could just dunk the whole end in the pot rather then pour the water onto it. It went well, the end wrapped nice and even and tight. The whole grip itself went nice and tight over the existing grip. Was my choice to keep the grip on as I got big mitts so I wanted a bit thicker of a grip to hold. Over all its nice but real sticky, will find out how long the grip last for use wise

Installed this on my son’s bat, simple to install! I’d suggest leaving the old grip underneath for a tighter fit.

Don’t hesitate, if you’re in need of a new bat grip or even upgrade to what you have, this is it! Next day delivery as well, great purchase. No signs of wear after four weeks of constant practice.