200cc Fluid Extractor & Fill Pump for Automotive Use - Oil Syringe with a 23" Hose & Two 12" Extension Tubes for Easy Oil Change

I needed this to extract old fuel from a deep tank and this worked perfectly. There are a lot of acccessory options for different needs but the pump itself works exactly as intended and described. Seems like good quality that should hold up well over time. Easy to assemble easy to use easy to clean. I recommend this product it is a good value for the money too!

I love it when a product is easy to use and actually works. This fluid extractor took me 2 minutes to figure out and assemble. And another 2 minutes to syphon extra oil out of my snowblower engine. Worked great and cleanup was easy. Not a drop of oil on my garage floor. When I was done I filled a plastic bottle with hot water and pumped it in to flush out the tiny amount of oil that was left inside the container/cylinder. So clean up was easy. Glad I bought this one instead of the other big seller on Amazon. Good product.

I had some other all orange colored brand that didnt have any suction after just one use. This looks like it will hold up. Tried it on water right now as wasnt ready for the trans fluid that I had needed to take out.. before I ordered and nothing worked. This didnt drip too much when you draw up fluid and then stop pulling the handle. Another brand let the fluid in it all back out again if you didnt keep pulling on the top shringe handle and if you had got to top then it was all running back out. Not supposed to do that if a good seal... so the two rubber ring seals on the shringe are holding good. Good product :)

Wish it held a little more fluid but overall good product. It helped me quite a bit when working on my cooling system on my truck. Made it much less messy overall being able to draw the liquid out.Easy to use and again did great job. Great for all fluids you may need to extract while doing a repair. Super useful and a great purchase. I’m m sure this will come in handy down the road. All plastic so easy to clean and maintain also.

This worked great to pump out my coolant reservoir. Very easy to use and clean.

Did the job on evacuating two stroke oil container on moped. Was too lazy to take off panels and remove the container altogether when converting to premix. Originally bought it to fill the gear oil to the exact recommended capacity on moped, ended up doing the service before I received this. Did the job as far as getting the oil out but oil was thick so you had to put quite The amount of pressure pulling back to suck the oil out due to the tube size. Either way it worked no issue and no leaks.

I was looking for a pump to drain a clogged sink. I tried a battery operated pump which worked for a short timen until it died. When I saw the picture of the FOUR UNCLES 200cc fluid extractor it looked like it might work. When it was delivered I took it out of the box and had it working in about 19 minutes. I am completely satisfied with the design and functionality of this pump.

Worked great for my Power Steering drain and fill. Enough capacity to empty the vessel after each session. I did 6 drain, cycle, fill, drains. Plunger was a little sticky at first and I learned not to push it all the way in to the end where is wanted to hang up. It would work great on differentials or transfer cases too when refilling them.

Nice quality, good suction, great attachments with locking mechanism, used to siphone excess oil from dipstick shaft as garage put in too much oil. I ordered a separate 1/4 OD ( 36” silicone tube to attache separately) Worked Great.

Worked perfectly. For gear oil buy a little larger Tygon tubing so you don’t have to push as hard. Gets almost all liquid out so just have to wipe with a paper towel to clean. This keeps cross contamination between using for different fluids.

une bonne invention , le travail est fait proprement

Worked good removing excess oil from Toyota, had to get a 1/4 OD hose to fit into the dipstick tube. You won’t get the proper suction unless you open the oil filler cap to let in air or the oil will get sucked back in and you’ll have resistance with the syringe.

I had high hopes for this product, based on the reviews. I bought this to make charging the oil in my snowblower a bit easier. However, the performance was horrible. To get anything to pull up, I had to go very slowly, and it only filled the bottom inch or so with oil on each pull. As soon as I stopped pulling the plunger, oil started to flow back out. Air was getting in somewhere from the top. Don't waste your money on this.