Motion Outdoor Lights Mains Powered - PIR Lights Outdoor - Bulkhead Wall Lights with Motion Sensor - IP44 Rated Security Lights - White Finish - E27 LED Compatible

So far, good PIR outdoor light with very good range. I have it set for maximum sensitivity, which is giving me more than 10 metres. Also has a time and Lux setting. Used a E27/ES LED cool white LED bulb.Fitting not too bad, although the push in connector is not suitable for multi core cable. In my case I used 6242Y cable which is solid copper core, so this worked well. If needed the push connector can be replaced by a screw type terminal connector.Ensure that all holes for screws and cable are well sealed to prevent water ingress.Overall, good quality PIR light at a good price.

This was replacing a similar unit which failed after several years, so should have been a doddle to fit. However, instead of the usual internal chocolate-box connector, it has a push fit connector which is only suitable for very thin and stiff wires. My existing wiring was much too thick, so I had to drill out the weather-proof grommet to fit the fatter cable and I cut off the connector to replace it with a chocolate-box connector. The earth cable then proved too short and needed replacing.Finally, all fixed and works a treat. Looks good also on my whitewashed wall.

Colour matches the UPVC frames of windows and doorsEasy to fit and works on sensor for security

Not great quality, internal push connection block needed to be changed for a screw block. Difficult to set sensor sensitivity and duration light stays on.

Having returned a light 3 times as expensive this one does everything I was hoping for.A little tricky to remove the lid but a broad blade or knife and gentle persuasion does the trick.You need to remove the connection shield to remove the connector block off its posts but then press the Lever down to insert the wire and release, no need for a screwdriver which I thought was useful.The sensor controls are easily adjusted and not as flimsy as other I have seen and the sensor swivels to allow some adjustment and tuning.Not claimed to be waterproof so I may put a bead of clear silicon around the lens but for the price that something I wouldn't complain about.

I already have one on the back of my house, and decided to install one on the front, very easy to install and has a light bulb fitting, not LED light, I have found sometimes the LED lights can be a problem! These lights have a bright light, and look great.

Nice look overall. Had to unscrew the reflector to fully access one of the mounting holes. Cable connector simple and effective (but I had to unscrew the earth to fully wire the mains cable. Plastic cover a bit fiddly, so one of the closing tabs now snapped off. Instructions and operation both good.

Good light great price