4 Way Car Standard Blade Fuse Holder Box (Apply to 1~40 AMP), with 10pcs Blade Fuse (3A/5A/7.5A/10A/15A/20A/25A/30A/35A/40A) and 8pcs Terminals, for Car/Boat/Marine/Trike

Worked great for organizing the fuses on my zero turn mower. Before installing this the fuses were just wired inline from the factory and located all over the place, mostly in hard to reach places. I mounted this under the seat pan and extended circuit wires accordingly. Now I see and reach all my fuses in an easy to get to spot. Nice that it came with an assortment of fuses and all the crimp end connectors needed.

I used this to manage power and ignition circuits on a Subaru into VW swap. 3 rd time I’ve used this fuse box for this kind of swap. Simple install.

I installed this holder in my boat. The holder itself was solid with good connections. The fuses provides I would not trust with anything critical. For the price, it is a very good buy, but I would recommend different fuses.

Had to replace the fuse panel on an old Ford pickup, this fuse panel's layout allowed several of the old fuse panel wires to be used without having to extend them, which was convenient. Seems well built, and getting the fuses with it is a nice bonus. Its most useful for circuits that require separate inputs, used a different fuse panel with a 12 volt bus for the others.

Used for power distribution, control on an automotive training board used in an auto class at the high school level career center

Makes for a nice fuse box for dune buggies etc.Only gave 3 stars for water resistant as there is no actual seal, just plastic covers that push on over top of fuses

Cons:- Not sealed/waterproof- labels on the cover are as-shown, not blankPros:- Easy to work with- works as intendedIf this was a sealed unit, and if the cover was blank to allow write-ins for each circuit than this would be a 5 star product. I used masking tape to covet the text on the cover and write-in a circuit description.

I was impressed when I got this fuse block. I bought the cheapest one on Amazon to convert my '72 Dodge van away from glass fuses. It's a little taller than I wanted for the stock mounting spot, but that's not the blocks fault.I expected thin flimsy plastic and a lid that doesn't snap well. I didn't get either of those. It's actually a nice piece. Bonus points for having two inputs so I can have constant hot fuses, and switched circuits without modifications.

Worked well. Replaced broken fuseholder.

Voldeed niet aan mijn verwachtingenKlipjes voor deksel zijn al afgebroken

Ottimo prodotto, lo consiglio

Installation facile et pratique avec les deux secteurs de branchements soit direct sur la batterie et l'autre sur l'ignition au besoin

Ottimo prodotto