10kV 10000V 30mA NG.A410EL Neon Sign Transformer Power Supply for Glass Neon Tubes 7-15mm Indoor Use with Ground Fault and Overheat Protection 120V Input

Worked! Repop neons from China fail a lot. This went right on, took 10 minutes.

I had a 25 year old Coors Light sign that stopped working a few years ago.. I finally decided to look into fixing it and ordered this.. Hooked up the 2 wires and presto.. good as new!

Well built product. Probably best quality to price ratio transformer you could buy. Makes no noise either, well insulated.

Got this to do some wood burning, this is my 1st time doing this, so I have nothing to compare with, it gets the job done & im happy with results. 1 downfall, would be nice to have an on/off switch instead of pull string...to be sure if it’s on or off

Stop working after 6 months!!

I used this transformer to replace a 9000 kV 130 ma unit that was in a four foot long by eighteen inch high neon sign that I have had and used since 1997. The sign would just flash momentarily in the center each time that the power switch was activated. I did a lot of looking at YouTube videos and they seemed to contradict one another as to what was wrong, so I just took a chance and tried a new transformer. This transformer is compact, has long leads to attach to the glass tubes, and it was very economical. Also, the actual size is approximately 6.5 inches long, about 2.5 inches wide, and 1.5+ inches high.

Works good. I'm satisfied

You pay for what you get here it feels extremely cheap and low quality but at least it is cheap to buy. I was having some issues getting it working and it makes it hard to trouble shoot because with the pull string you cant tell if its on or and there is no indicator light. When working with 10,000 volts you want to make sure the transformer is de, energized before you touch it.