Thermal Grizzly TG Putty Pro - 30 Gram - High-Performance Electrically Non-Conductive Thermal Putty for GPU and PCB Applications

Worked great. Easy to use. Using the speeding equipment made it even easier. I did over do it and I had to clean up a little but it wasn’t bad. Comes off easily. A little can do a long way

Great thermal paste and putty. It is worth the price. I was able to lower temps by 10 degrees. Easy to apply.

This stuff is amazing. I did a re-putty on my Gigabyte 5070ti Windforce to avoid the poorly-formulated stock putty from running out and leaving my components exposed more than it already had.Given the 5070ti is a mid-range card (albeit at a high-end price), I did not feel like spending more on the "Pro" putty. All I was hoping was to meet the stock performance while avoiding running out.I only needed about 15g to replace the factory locations, and used the remaining putty between my backplate and PCB along the power rails and above the 12v connector.I was quite pleased to find that this outperforms the factory "gel" by 10-15°! My memory temps are now lower than my core temps. I paired the putty with TG's Phasesheet for the core, and could not be happier with the combo.

Overall a great product. Take this with a grain of salt as the last time I looked was quite awhile ago but I believe it's helped lower VRM temps on my GPU about 10-12 deg when under load.All in all, while pricey for the amount you get(hence the one star deduction), it could be worth it.Notes:- You may have to use generous amounts depending on your situation, so I'd recommend to buy at least 2 vials unless you have a store nearby that also sells this. I almost ran out; better to have another vial available and ready rather then run out and have to wait to get more. Hopefully you'll only need one and can return the second one.- Sticking it in the fridge does help with usability; that said it's not terrible when it's room temp. The one thing I would say though is that it makes it a bit more difficult to get exactly the right amount. It'd be way easier to get the exact amount to spread across the component you want to use it on, the question would then be, given how little you get with each vial, is whether or not the amount too much or too little in terms of being able to make contact with your waterblock/air cooler while still covering the components.- Use at least 2 of the spatulas; one to scoop, one to spread. For me it was a lot easier to spread with a clean(er) spatula than a dirty one.- cleanup seems do-able with the isopropyl alcohol, but will may be a bit tougher to clean up in between components depending on it's state and/or how it was applied.

I don't have to worry about the width of the sticker anymore, just apply this and so far it has been working great. The only issue is that its a mess to clean up. My NVME still has some residue on it after i wipe everything off.

top notch!

Thermal Grizzly is a name that we all know as top spec performance. As such, it comes with a hefty price tag. Unfortunately, it is unable to justify the price tag as competitors are near the performance with lesser prices. Other than value, the application of this paste is somewhat annoying. I was between using the spatula and flathead, and putting on nitrile gloves and just using my fingers. Once applied, it gave good performance on my Sapphire 7900xtx Nitro+, but due to the small amount given at such a large price I had quite an anemic application. It actually was cheaper to get 50g of other putty instead of the additional 30g needed to finish it out. Because of this I have to give it 3 stars. Good product, but too expensive.

Used some TG putty (and TG pads and TG paste) to re-paste an EVGA 3080 and now it is running so cool I am able to over clock it a little more than before with no stability issues. Highly recommend.